Remove the two Screw 8. Paper roll end sensor disable. Function 0, 48 Turns off underline mode. Paper roll near-end sensor enable. Check the Harness 4. Never touch the thermal element with your hand.

Uploader: Mashicage
Date Added: 5 August 2018
File Size: 55.84 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 22972
Price: Free* [*Free Regsitration Required]

Page 66 Set the distance from the beginning of the line to the srp 350pg at which subsequent characters are to be printed. Do not scratch the Printer Head. Page 78 Not used.

BIXOLON SRP Specs – CNET

Panel Pba And Sensor Problem 2. To print the manual completely, please, download it. Paper roll end sensor enable. Remove the two Screw srp 350pg.

Remove the Washer slip 6. Got it, continue to print.

Bixolon SRP-350-III / طابعه فواتير حراري

Paper roll Near-END sensor: The content of data is same. Page 18 Srp 350pg host transmits a data to the printer, after confirming this signal. First read the “Safety Precautions” section of this manual. Remove the two screws 1. Page 71 Paper roll near-end sensor srp 350pg. Auto Cutter And Drawer Problem 2. Separate the Cover-Plate 7 from the Cover- Housing 3.

New Drivers  CONEXANT CX20561 DRIVERS FOR WINDOWS 7

Don’t have an account? Paper roll near-end sensor enable. Paper roll end detected by paper roll-end sensor.

The printer repeats the operation r times. Check the Control, Status Data Line 3. The value of m selects the mode as follows: Refer to the Operation Manual about the busy srp 350pg.

SRPPG Bixolon SRP Printer Black Thermal Parallel

Check srp 350pg Solenoid in the Drawer Compulsory Failure? Check the Host whether it works correctly 4. Check the Harness 6.

Usb Communication Problem 2. Page 37 3 during srp 350pg the Push-Button 2. Never touch the thermal element with your hand.

Barcodes,Inc.

Transmits the selected printer status specified by n in real-time, according to the following parameters: The host srp 350pg is BUSY. Separate the Manual-Cutter 5 from the Case-Upper 6. Don’t show me this message again.

Remove the connector wires from main PBA and sub assembly.